Skip to product information
1 of 2

Revitalizing Shower Filter Replacement Cartridge

Regular price €95,95 EUR
Regular price Sale price €95,95 EUR
Sale Sold out
Shipping calculated at checkout.
Shipping and Returns

Shower Cartridge Replacement Instructions

  • Remove the entire filter system from your shower pipe by turning the chrome swivel connector counter clockwise (or to the left).
  • Then remove the showerhead by turning the connector counterclockwise (or to the left). Do not remove the filter cartridge while the filter is still attached to the shower pipe, this may cause damage to the filter where it connects to the shower pipe.
  • While holding the upper filter housing firmly, remove the lower filter cartridge by turning it to the left, (or counterclockwise). This cartridge may be disposed of with your trash, as it poses no environmental hazards.
  • Unwrap the new replacement cartridge and remove the yellow pull tab label and the yellow plastic shipping cap from the top end of the cartridge.
  • After making sure that the upper housing O-Ring is still in place, rub a coating of cooking oil on the exposed surface of the O-Ring to ensure a proper seal. Next, install the new lower cartridge by turning it to the right. Tighten firmly by hand; if this lower filter is not tightened firmly it will leak around the seam between the upper filter housing and the cartridge.
  • Re-attach the filter system to your shower pipe by turning the chrome swivel collar clockwise (or to the right). Make sure that the connector washer in the chrome swivel connector is still in place.
  • Before re-attaching the showerhead, flush and activate the filter media into a bucket until the water runs clear. Then re-attach the showerhead and enjoy.

NOTE: The initial surge of water will be discolored due to carbon fines and will soil your shower stall or tub. You may wish to capture the first one or two gallons of water in a bucket or pitcher. This carbonized water is very beneficial for plants and to the environment and can be discarded in a plant bed or down the drain.

For the initial flushing use cold water. Run water until clear and then turn the water off and then back on again. Repeat this on/off flushing until the initial surge of water is completely clear and free from carbon fines.

After the water has turned clear, adjust the temperature to your normal shower setting. Notice that there is a delay in temperature equalization due to the filter media warm up period. Take this equalization period into account when showering, make slight adjustments and wait 30 seconds for temperature change.

    Replacement Cartridge Installation Video

    Disclaimer: While we work to ensure that product information is correct, on occasion manufacturers may alter their products descriptions and/or ingredient list. Actual product packaging and materials may contain more and/or different information than is shown on our website. We recommend that you do not solely rely on the information presented and that you always read labels, warnings, and directions before consuming any product. Any health information provided in this product description is for informational purposes only. We do not provide medical advice, diagnosis, or treatment. This information is not meant to replace or substitute professional medical advice. No statements in this description were evaluated by the Food and Drug Administration. The product described herein is not intended to diagnose, treat, cure, or prevent any disease.